Setting the Countdown Start
Time
The countdown start time can be set in 1-
minute units up to 24 hours.
If a timer countdown operation is in
●
progress, reset the timer to its current start
time before performing this operation.
Using the Timer
l
1.
Enter the Timer Mode.
Navigating Between Modes
l
2.
Loosen the crown and then pull it out to the
first click.
3.
Rotate the crown to change the
countdown start time setting.
Seconds
Minutes
Hours
24-hour
4.
Push the crown back in and then lock it.
Note
To specify a countdown start time of 24
●
hours, align the small hour and minute
hands with 12 o'clock, so the small 24-
hour hand aligns with 24.
If you do not perform any operation for
●
about two minutes after pulling out the
crown, crown operations will
automatically become disabled. If that
happens, push the crown back in and
then pull it out again.
Watch Operation Guide 5672
Using the Timer
1.
Enter the Timer Mode.
Navigating Between Modes
l
2.
Press (B) to start the timer countdown.
A beeper sounds for 10 seconds when the
end of the countdown is reached.
To pause an ongoing countdown, press
●
(B). You can reset a paused countdown
to its start time by pressing (D).
3.
Press any button to stop the tone.
Crown
Adjusting Hand and
Day Indicator
Alignment
Strong magnetism or impact can cause the
hands and/or the day indicator to go out of
alignment. If this happens, adjust hand and
day indicator alignment.
The watch performs alignment of the hour
●
hand, minute hand, second hand, and 24-
hour hand automatically.
Using CASIO WATCHES to
Adjust Hand and Day
Indicator Alignment
If the watch is paired with a phone, you can
also use CASIO WATCHES to adjust hand
and day indicator positions.
Adjusting Hand and Day Indicator
l
Alignment
Adjusting Hand and Day
Indicator Alignment
1.
Loosen the crown and then pull it out to the
second click.
2.
Hold down (D) for at least five seconds
until the second hand points to 12 o'clock .
Release the button when the second hand
reaches 12 o'clock.
This will start auto alignment of the hour
hand, minute hand, second hand, and 24-
hour hand.
After auto alignment is complete, the
●
hands should be in the positions shown
below.
Hour hand
Minute hand
Second hand
24-hour hand
3.
Press (C).
Confirm that the 24-hour hand is at the 24
position (straight upwards).
Crown
25