Hand Alignment Adjustment; Other Settings - Casio Edifice ECB-500D-1A Operation Manual

Hand Alignment
Adjustment
Strong magnetism or impact can cause the
time indicated by the analog hands to become
different from the time on the digital display. If
this happens, correct the hand position.
Getting ready
Perform this procedure in the Timekeeping
Mode. Use (D) to navigate to the Timekeeping
Mode.
Navigating Between Modes
l
Timekeeping Mode
Adjusting Hand Alignment
1.
Hold down the (A) button for about five
seconds.
[H.SET] will appear, and then [SUB] will
flash on the display.
Small hour hand
Small
minute hand
2.
If the small hour and minute hands are not
at 12 o'clock, use (B) and (E) to move them
there.
Holding down (B) or (E) moves the
●
hands at high speed.
3.
Press (D).
This enables correction of hour and
minute hand alignment.
Watch operations are disabled while
●
hands are moving.
Minute hand
Hour hand
4.
If the hour and minute hands are not at 12
o'clock, use (B) and (E) to move them
there.
Operation Guide 5427
5.
Press (D).
This enables adjustment of second hand
alignment.
6.
If the second hand is not at 12 o'clock, use
(B) and (E) to move it there.
7.
Press (A) to return to the Timekeeping
Mode.

Other Settings

Getting ready
Perform this procedure in the Timekeeping
Mode. Use (D) to navigate to the Timekeeping
Mode.
Navigating Between Modes
l
Timekeeping Mode
Enabling the Button
Operation Tone
Use the procedure below to enable or disable
the button operation tone.
1.
Hold down the (A) button for about two
seconds.
[SET] will appear first, followed by the
Home Time City name.
2.
Press (D) twice until the current setting
([KEY♪] or [MUTE]) flashes on the display.
3.
Press (E) and the current setting ([KEY♪]
or [MUTE]) will appear on the display.
[KEY♪]: Enables the operation tone.
[MUTE]: Operation tone is muted.
4.
Press (A) twice to exit the setting screen.
Configuring Power Saving
Function Settings
1.
Hold down the (A) button for about two
seconds.
[SET] will appear first, followed by the
Home Time City name.
2.
Press (D) five times so [POWER SAVING]
is displayed.
3.
Press (E) to toggle the setting between
enabled (on) and disabled (off).
[on]: Power Saving enabled.
[- -]: Power Saving disabled.
4.
Press (A) twice to exit the setting screen.
Note
For details about Power Saving, see
●
"Power Saving Function".
14