Do not operate the crown or buttons while ー retailer or to an authorized CASIO service Example of Daily Use your watch is submersed in water or wet. center. Hand washing, rain Avoid wearing your watch while in the ー ...
Page 3
Watch Operation Guide 5674 Temperature Chemicals Leather Band ● ● ● Never leave your watch on the dashboard Do not allow your watch to come into Allowing your watch to remain in contact ● ● ● of a car, near a heater, or in any other...
Display figures may be difficult to read when ● scrub the band with a weak solution of water retailer or to an authorized CASIO service viewed from an angle. and a mild neutral detergent, or with soapy center.
Watch Operation Guide 5674 Battery Replacement Leave battery replacement up to your ● original retailer or authorized CASIO service center. Have the batteries replaced only with the ● type specified in the “Specifications”. Use of a different battery type can cause malfunction.
Watch Operation Guide 5674 General Guide Watch Face and Display Before Getting Indicators Started... ① ② ① ② This section provides an overview of the watch and introduces convenient ways it can be ③ ⑦ used. ⑧ Watch Features ④...
Watch Operation Guide 5674 Navigating Between Modes Cycling Between Viewing the Face in the Dark Timekeeping Mode Digital Each press of (C) cycles between watch The watch has an LED light that you can turn Display Contents modes. on for reading in the dark.
Watch Operation Guide 5674 Time Adjustment Use (B) and (D) to select an illumination Press (C). duration. Press (B) or (D) to change the summer [1]: 1.5-second illumination Use the procedures in this section to adjust the time setting. date and time settings.
Page 9
Watch Operation Guide 5674 Keep pressing (C) until the setting you Repeat steps 3 and 4 to select time and Press (B) or (D) to select [12H] (12-hour want to change is flashing. date settings. timekeeping) or [24H] (24-hour timekeeping).
Watch Operation Guide 5674 World Time City Setting Swapping Your Home Time World Time and World Time Use the procedure in this section to select a World Time city. If you are in an area that World Time lets you look up the current time Enter the Timekeeping Mode.
Watch Operation Guide 5674 Enabling the Hourly Time Alarm Use (B) and (D) to change the hour setting. Signal Holding down (B) or (D) scrolls through ● settings at high speed. The watch will beep when an alarm time is Enter the Alarm Mode.
Watch Operation Guide 5674 Measuring a Split Time Stopwatch Enter the Alarm Mode. Navigating Between Modes Enter the Stopwatch Mode. The stopwatch measures elapsed time in Use (B) and (D) to scroll through the alarm Navigating Between Modes 1/100-second units for the first hour, and in 1- ([AL1] to [AL5]) and hourly time signal second units after that for up to 24 hours.
Watch Operation Guide 5674 Timing the First and Second Timer Use (B) and (D) to change the timer hours Place Finishers setting. Holding down (B) or (D) scrolls through The timer counts down from a start time ● Enter the Stopwatch Mode.
Watch Operation Guide 5674 Using the Timer Hand Alignment Other Settings Adjustment Enter the Timer Mode. This section explains other watch settings you Navigating Between Modes can configure. Strong magnetism or impact can cause the Hour, minute time indicated by the analog hands to become different from the time on the digital display.
Watch Operation Guide 5674 Other Information City Offset Press (A) to exit the setting screen. SEL: Seoul SEOUL Note This section provides non-operational TYO: Tokyo information you also need to know. Refer to TOKYO While the setting is being configured, ●...
Watch Operation Guide 5674 Specifications Troubleshooting Other : Operation tone ON/ OFF; hand shift Accuracy at normal temperature : Power Supply : ±15 seconds a month SR726W x 2 Indicators and Current Time Timekeeping : Battery life: Approximately 3 years...
Page 17
Watch Operation Guide 5674 World Time The time for a World Time City is not correct. The summer time setting (standard time/ summer time) is wrong. World Time City Setting Alarm The alarm does not sound. Is the alarm setting turned on? If it isn’t, turn it on so it will sound.
Need help?
Do you have a question about the 5674 and is the answer not in the manual?
Questions and answers