Timer
The timer counts down from a start time
specified by you. A beeper sounds when the
end of the countdown is reached.
The beeper is muted when battery power is
●
low.
Setting the Time
The countdown start time can be set in 1-
second units up to 24 hours.
If a timer countdown operation is in
●
progress, reset the timer to its current start
time before performing this operation.
Using the Timer
l
1.
Enter the Timer Mode.
Navigating Between Modes
l
2.
Hold down (A) for at least two seconds.
This causes the hours digits to flash.
Hours
3.
Use (B) and (D) to change the timer hours
setting.
Holding down (B) or (D) scrolls through
●
settings at high speed.
4.
Press (C).
This causes the minutes digits to flash.
Minutes
5.
Use (B) and (D) to change the timer
minutes setting.
Watch Operation Guide 3495
6.
Press (C).
This causes the seconds digits to flash.
7.
Use (B) and (D) to change the seconds
setting.
8.
Press (A) to exit the setting screen.
Note
While the setting is being configured,
●
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
Setting a start time of [0:00 00] will
●
perform a countdown of 24 hours.
Using the Timer
1.
Enter the Timer Mode.
Navigating Between Modes
l
2.
Use the operations below to perform a
timer operation.
(Measurement operation starts.)
A beeper will sound for 10 seconds to
●
let you know when the end of a
countdown is reached.
To reset a paused countdown to the
●
start time, press (A).
3.
Press any button to stop the tone.
Seconds
Hour, minute, second
D
Start
D
Pause
D
Resume
(Time up)
Other Settings
This section explains other watch settings you
can configure.
Changing the Date Display
Format
You can select either month/day or day/month
as the date display format.
1.
Enter the Timekeeping Mode.
Navigating Between Modes
l
2.
Hold down (A) for at least two seconds.
Release the button when the name of the
currently selected Home City appears on
the display.
3.
Press (C) nine times.
This displays a screen for selecting the
date display format.
4.
Use (D) to select a date display format.
M: Month
DD: Day
Month, day
5.
Press (A) to exit the setting screen.
Note
While the setting is being configured,
●
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
Home City
Day, month
16