Connections; Power Distribution Unit - IBM 9306 Hardware Maintenance Manual

Connections

Server Rack
Keyboard
Connection

Power distribution unit

Note: For information and installation instructions for the IBM NetBAY Rack Power
Note: To remove the power distribution unit, you might need to remove the right
To remove the power distribution unit:
1. Power-off the rack.
2. Disconnect all power plugs from the power distribution unit.
3. Using a Phillips screwdriver, remove the four screws from the front of the power
4. Remove the power distribution unit from the cabinet.
AC Power
Input
Server
Server Rack
Monitor
Monitor
Connections
Connection
M V V V V V
O G G G G G
N A A A A A
O 1 2 3 4 5
K M
K M K M K M K M K M
B O
1 1 2 2 3 3 4 4 5 5
O U
Server Rack
Mouse
Server Keyboard
Connection
and Mouse
Connections
Distribution Units, see "Installing Optional Devices" on page 101".
side cabinet panel, the server installed in sliding tray 2 (in the primary IBM
PC Server Rack), or sliding tray 5 (in the IBM PC Server Expansion Rack).
distribution unit.
Note: These screws are held in place by nuts and washers. Hold the nut while
you are unscrewing the screw to prevent the nut and washer from falling
into the bottom of the cabinet.
Server Selector
Unit On-Off
Switch
V V V
G G G
A A A
6 7 8
K M K M K M
6 6 7 7 8 8
Type 9306 Models 4QS, 4QX, 9QS, 9QX, 9TS, 9TX
43