IBM 9306 Hardware Maintenance Manual page 104

16. To attach the front of the tray to the rack cabinet, pull the tray halfway out of
17. Connect the keyboard and mouse connectors to the extension cables that
18. Connect the keyboard, video, and mouse connectors to either a server or a
19. Refer to the flat panel monitor documentation that comes with this kit for
Note: When the monitor and keyboard are not in use, or if your rack cabinet is in a
If you are installing an optional console switch continue to "Installing an optional
console switch" on page 95.
94
Hardware Maintenance Manual: IBM PC Server/Enterprise Racks Types 9306, 9308
the rack cabinet so that you can access the front of the rails; then, use four of
the screws from the miscellaneous hardware kit to secure the slide-rail
brackets to the rack cabinet.
Note: Do not install screws in the slide-rail middle holes. These holes are for
the security screws on the front of the tray.
come with this kit; then, connect a power cord to the power supply.
console switch in your rack cabinet; then, connect the power cord to a properly
grounded electrical outlet. Neatly route cables within your rack cabinet and
secure them with cables straps along the way.
information about operating your monitor. Refer to the space-saver keyboard
documentation for information about operating your keyboard.
vibration-prone area, tighten the security screws on the front of the tray to
secure the tray inside the rack cabinet.
Security screw