Setting Up The System; Precautions - Sony SX-1062 Operating Instructions Manual

Setting Up the System

Setting Up the System

Precautions

Safety precautions
Power supply
• Operate the unit with a power source as specified in
"Specifications" (page 46).
• Do not drop or place heavy objects on the power
cord. If the power cord is damaged, turn off the
power immediately. It is dangerous to use the unit
with a damaged power cord.
• Disconnect the power cord from the AC outlet by
grasping the plug, not by pulling the cord.
Keep foreign objects out of the cabinet
Dropping flammable or metal objects into the cabinet,
or spilling liquids onto the cabinet can lead to
accidents.
In case of malfunctions
If you notice any unusual sound, smell or smoke, turn
off the power immediately, disconnect the power
supply and contact your Sony dealer.
Infrared
The infrared emitted by the SX-9133 Infrared Radiator
is set to a level that is safe for human beings. We
recommend, however, that you do not stare at the
infrared radiator for a long time.
Cleaning
Clean the cabinet and panels by wiping with a soft, dry
cloth. For severe stains, moisten the cloth with a small
amount of neutral solvent, and finish by wiping with a
dry cloth. Do not use alcohol, benzine, thinner or
volatile liquids, as these may discolor or damage the
cabinet surface.
36
Lighting
Use the following lighting in halls where the system is
used.
• Incandescent electric light: Incandescent electric light
such as halogen bulbs or krypton bulbs.
• Glow-started low-wattage fluorescent bulbs
Note
Do not use the following lights because they cause the
infrared noise. When video projectors or slide
projectors are used in the hall, strong noise occurs
whenever the projectors are turned on or off.
• Inverter type fluorescent bulbs.
• High efficiency type (switching method) fluorescent
bulbs
For customers in Netherlands (SX-2130
only)
Voor de klanten in Nederland (Alleen
SX-2130)
• Dit apparaat bevat een Li-ion batterij voor memory
back-up.
• De batterij voor memory back-up is vastgesoldeerd
op de RX-12 printplaat BT-201.
• Raadpleeg uw leverancier over de verwijdering
van de batterij op het moment dat u het apparaat bij
einde levensduur afdankt.
• Gooi de batterij niet weg, maar lever hem in als
KCA.
• Bij dit produkt zijin batterijen geleverd. Wanneer
deze leeg zijn, moet u ze niet weggooien maar
inleveren als KCA.