Sony SX-1062 Operating Instructions Manual page 39

Connecting the infrared radiator cable
How to connect the connecting cable to the infrared
radiator depends on the cable wiring.
Use the RG-6A/U 75-ohm coaxial cable with BNC
connectors.
When the connecting cable is routed through the
wall
To prevent burden on the cable, pass the cables
through the holes of the infrared radiator chassis and
cross them over inside the infrared radiator, and then
connect each cable to LINE IN and LINE OUT.
When using two or more infrared radiators
You can increase the number of infrared radiators
according to the size of the hall. Up to five infrared
radiators can be connected in series per group.
When using multiple infrared radiators, the distance
between the first infrared radiator and the last one
should be within 8 m (26 feet).
SX-1062
Within 60 m (197 feet) when
using the RG-59B/U
connecting cable
Within 160 m (525 feet) when
using the RG-6A/U
connecting cable
1) You can connect up to five infrared radiators in series to
each RADIATOR output connector of the infrared
transmitter via infrared interface unit.
When the connecting cable is routed over the wall
Remove the notch from the infrared radiator hood and
pass the cables through the notch, then connect each
cable to LINE IN and LINE OUT.
If you install them more than 8 m (26 feet) apart, clear
sound will be difficult to obtain.
The following shows the length of the cables
connecting the infrared transmitter, infrared interface
unit and infrared radiator.
SXA-33
SX-9133 NO.1 1)
Within 32 m (105
feet) when using
the RG-59B/U
connecting cable
SX-9133 NO.2 SX-9133 NO.3 SX-9133 NO.4 SX-9133 NO.5
The distance between the SX-9133 NO.1 and the
last SX-9133 should be within 8 m (26 feet) when
using the RG-59B/U connecting cable
Notch
39