Sony SX-1062 Operating Instructions Manual page 35

5 POWER switch
Turns the power on or off.
6 POWER indicator
Lights when the power is turned on.
7 AC IN (AC power input) connector
Connect to an AC outlet using the supplied AC power
cord.
8 CHARGE TIMER indicators
Indicate the elapsed charging time. The indicators
light up green, one by one, every hour. All five
indicators will be lit 5 hours after charging starts.
After 5 hours, the red FLOAT indicator also lights.
9 OPERATION indicators
Light up green when charging has been completed
successfully. The unit features 17 charge control
circuits to control the 50 charge pockets. All 17
OPERATION indicators light when these charge
control circuits are charging the batteries correctly.
The indicator numbers correspond to the pocket
numbers.
0 BATTERY CHECK indicators
Indicate the battery charge. If you insert a infrared
receiver to check its battery's charge, the indicators
light according to the current charge.
LOW (red): The charge is less than 35%. The
battery must be charged.
MED (green): The charge is 36% to 84%. You can
use the infrared receiver for about 5 hours.
HIGH (green): The charge is more than 85%. It is
not necessary to charge the receiver's battery.
!¡ BATTERY CHECK pocket
Used to check the charge of an infrared receiver before
use or after charging its battery. Insert the infrared
receiver whose battery charge you want to check.
Note
Insert the infrared receiver into the pocket such that the
infrared receiving lens faces the charger's operating
panel.
35