Table of Contents
Advertisement
Conference System
Model:
SX-M100
SX-C100A/SX-C150
SX-D100A/SX-D150
SX-T100
Operating Instructions
Before operating the unit, please read this manual thoroughly
and retain it for future reference.
© 1994 by Sony Corporation
Control Unit
Telephone Coupler
3-759-749-14 (1)
Chairman's Unit
Delegate's Unit
Advertisement
Table of Contents
Related Manuals for Sony SX-M100
Summary of Contents for Sony SX-M100
- Page 1 Conference System Model: SX-M100 SX-C100A/SX-C150 SX-D100A/SX-D150 SX-T100 Operating Instructions Before operating the unit, please read this manual thoroughly and retain it for future reference. Control Unit Telephone Coupler © 1994 by Sony Corporation 3-759-749-14 (1) Chairman’s Unit Delegate’s Unit...
- Page 2 Owner’s Record The model and serial numbers are located on the rear of the SX-M100 and on the bottom of the SX-C100A/ D100A/T100. Record the serial numbers in the spaces provided below. Refer to them whenever you call upon your Sony dealer regarding these products.
-
Page 3: Table Of Contents
Outline ... 4 Features ... 4 System Configuration ... 5 Location and Function of Parts and Controls ... 6 SX-M100 Control Unit ... 6 SX-C100A/C150/SX-D100A/D150 Chairman’s Unit/Delegate’s Unit .. 9 SX-T100 Telephone Coupler ... 13 Setting Up the System ... 14 Precautions ... -
Page 4: Outline
Outline Features The SX-M100 conference system is a flexible discussion system that can be configured with the versatile units introduced below. The standard system supports a conference of up to 60 delegates. Connecting the SX-E120 Expansion Unit (not supplied) allows the system to support up to 120 delegates. -
Page 5: System Configuration
Operator section SX-T100 Telephone Coupler MONITOR POWER MONITOR PHONES a) You can also use other combination of the SX-C150/SX-D150. System configuration SX-M100 Control Unit ORIGINAL MIC/LINE 1 MIC/LINE 2 D/C UNIT MIC D/C UNIT SP MIC/LIMIT DIRECT ACCESS SEAT ASIGN ON/OFF... -
Page 6: Location And Function Of Parts And Controls
Location and Function of Parts and Controls SX-M100 Control Unit Front panel POWER switch PHONES connector MONITOR volume control MONITOR POWER PHONES Rear panel EXT UNIT IN/OUT connectors EXT IN-1 MIC/LINE connectors and MIC/LINE switch EXT UNIT EXT IN-1 EXT IN-2... -
Page 7: Level Meter
1 POWER switch Setting the switch to ON (1 ) turns the power on. The level meter will light. Setting the switch to OFF ( ) turns the power off. 2 PHONES connector (stereo phone jack) Connect 8-ohm stereo or monaural headphones. Note that the output is monaural even when stereo headphones are connected. - Page 8 Location and Function of Parts and Controls 0 EXT IN-1 MIC/LINE (external 1 microphone/ line signal input) connectors and MIC/LINE switch EXT IN-1 MIC/LINE connectors Accept an external audio signal. MIC connector (XLR type): Connect a rostrum or conference hall microphone. Note When you use a connecting cable with an XLR connector, pin No.1 and the case (metal part) of...
-
Page 9: Sx-C100A/C150/Sx-D100A/D150 Chairman's Unit/Delegate's Unit
SX-C100A/C150/SX-D100A/D150 Chairman’s Unit/Delegate’s Unit The following two combinations of the chairman’s unit and delegate’s unit are available for use with the system. • SX-C100A/SX-D100A Chairman’s Unit/Delegate’s Unit • SX-C150/SX-D150 Chairman’s Unit/Delegate’s Unit This section explains the location and function of parts and controls of the chairman’s unit and delegate’s unit. - Page 10 Location and Function of Parts and Controls SX-C150/SX-D150 Chairman’s Unit/Delegate’s Unit Chairman’unit top REC OUT connector † ! º Earphone jacks VOL control Chairman’unit/delegate’s unit bottom Output connector Delegate’s unit top REC OUT connector † ! º Earphone jacks VOL control PRIORITY MIC ON/OFF MIC ON/OFF Microphone and...
- Page 11 For SX-C100A/SX-D100A (20-pin multi- connector) Connect the cable with a 20-pin multi-connector of the chairman’s unit/delegate’s unit placed opposite the SX-M100 Control Unit and the next chairman’s unit/delegate’s unit. For SX-C150/SX-D150 (D-sub 15-pin) Connect to the input connector on the next chairman’s unit and delegate’s unit.
- Page 12 Location and Function of Parts and Controls When the MIC ON/OFF button of the delegate’s unit is pressed under the condition where the PRIORITY button of the chairman’s unit is held down, the MIC ON/OFF button indicator and microphone indicator blink for about 3 seconds to tell the user that the microphone cannot be enabled.
-
Page 13: Sx-T100 Telephone Coupler
SX-T100 Telephone Coupler 1 CONTROL UNIT connector (6-pin multi- connector) Connect to the TELEPHONE COUPLER connector of the SX-M100 Control Unit, using the connecting cord supplied with the SX-T100. 2 Power indicator This indicator lights when the telephone coupler power is turned on. -
Page 14: Setting Up The System
System Connection This section explains how to connect the system. Chairman’s unit/delegate’s unit and interpreter’s unit The SX-M100 Control Unit is provided with four DELEGATE’S/CHAIRMAN’S UNIT connectors. Up to 15 chairman’s/delegate’s units can be connected to each of the DELEGATE’S/ CHAIRMAN’S UNIT connectors in serial... - Page 15 C150 and SX-D150 units can be connected to one line. The specially designed cables are used to connect these units to the system. For details, contact your Sony dealer. How to connect cables of the SX-C100A/SX-D100A The figure below shows how to connect and disconnect the 20-pin multi- connectors of the chairman’s/delegate’s unit and RK-1710/1713 connecting...
-
Page 16: Turning On The Power Of The System
Setting Up the System Turning On the Power of the System Turn on the power of the units connected to the EXT IN-1/2 connectors of the control unit. Set the POWER switch of the control unit to ON. When necessary, set the POWER switch of the telephone coupler to ON. ORIGINAL MONITOR MIC/LINE 1... -
Page 17: Preparing The Control Unit
Preparing the Control Unit Adjusting the audio level Adjust the audio signal output to the chairman’s/delegate’s unit and input from the external equipment connected to EXT IN-1/2 before the conference. Adjusting the output level of the audio signal to the chairman’s unit/ delegate’s unit Level meter Chairman’s unit/delegate’s unit... - Page 18 Setting Up the System Adjusting the input level of the audio signal from equipment connected to EXT IN-1/2 connectors • To adjust the output of the conference microphone, set the MIC/LINE switch • To adjust the output of external equipment, set the MIC/LINE switch of the Adjust either MIC/LINE 1 or MIC/LINE 2, corresponding to the equipment to be adjusted, so that the level meter pointer indicates about 0 VU.
-
Page 19: Operation During A Conference
Operation During a Conference Operations Performed by the Chairman and Delegates Operations common to both the chairman and delegates The chairman and delegates can both talk and listen by using their individual unit. The operations are the same. To speak Press the MIC ON/OFF button of the unit. -
Page 20: Taking Part In A Conference Via A Telephone
Operation During a Conference Taking Part in a Conference via a Telephone A person can take part in a conference from a remote location by using the SX-T100 Telephone Coupler . Set the POWER ON/OFF switch of the telephone coupler to ON. Set up a telephone connection with the party who will take part in the conference. -
Page 21: Troubleshooting Guide
Should a problem arise in your system, check the system while referring to the instructions in the table below. If the system continues to malfunction after applying the following checks and remedies, contact your nearest Sony dealer. The system indicates the problem by lighting the microphone indicator and MIC ON/OFF button of chairman’s/delegate’s units. -
Page 22: Specifications
Specifications SX-M100 Control Unit Input/output connectors DELEGATE’S /CHAIRMAN’S UNIT (20-pin multi-connector) 4 TELEPHONE COUPLER (6-pin multi connector ) 1 Input EXT IN-1/EXT IN-2 MIC (XLR 3-pin connector) 1 Balanced type, input level 0.77 mV (–60dBs), for microphone having low impedance... - Page 24 Sony Corporation Printed in Japan...