Lamp Replacement; Lamp Replace Counter - Sanyo PLV-60HT Owner's Manual

Sanyo owner's manual multimedia projector plv-60ht

Hide thumbs Also See for PLV-60HT:

Service manual (116 pages)

Table Of Contents

Table of Contents

When the life of the Lamp of this projector draws to an end, the LAMP REPLACEMENT Indicator lights yellow. When the

image becomes dark or the color of the image becomes unnatural, replacement of the Lamp is required.

CAUTION

For continued safety, replace with a lamp assembly of the same type.

Allow projector to cool for at least 45 minutes before you open the lamp cover. The inside of projector can

become very hot.

Do not drop the lamp assembly or touch the glass bulb! The glass can shatter and may cause injury.

Follow these steps to replace the lamp assembly.

Turn off projector and disconnect AC plug. Allow projector to

cool for at least 45 minutes.

Remove a screw with a screwdriver and remove Lamp Cover.

Remove 2 screws and pull out Lamp Assembly by grasping

Handle.

Replace Lamp Assembly with a new one and tighten 2 screws.

Make sure that Lamp Assembly is set properly. Replace Lamp

Cover and tighten a screw.

Connect AC Power Cord to projector and turn on projector.

Reset Lamp Replace Counter (refer to the section "Lamp

Replace Counter" below).

NOTE : Do not reset Lamp Replace Counter when Projection

Lamp is not replaced.

ORDER REPLACEMENT LAMP

Replacement Lamp can be ordered through your dealer. When ordering the Lamp, give the following information to the

dealer.

Model No. of your projector

Replacement Lamp Type No. : POA-LMP28

Be sure to reset Lamp Replace Counter when Lamp Assembly is replaced. When Lamp Replace Counter is reset, LAMP

REPLACE Indicator stops lighting.

Turn projector on, press MENU button and ON-SCREEN MENU will appear. Press POINT LEFT/RIGHT button(s) to

move a red frame pointer to SETTING Menu icon (refer to page 36, 37).

Press POINT DOWN button to move a red frame pointer to "Lamp counter reset" and then press SELECT button. The

message "Lamp replace counter reset?" is displayed. Move the pointer to [Yes] and then press SELECT button.

Another confirmation dialog box appears and select [Yes] to reset Lamp Replace Counter.

Do not reset Lamp Replace Counter except after Projection Lamp is replaced.