Table of Contents
Advertisement
When using this Remote Control Unit as Wired Remote Control, Connect Remote Control Unit to R/C JACK with
Remote Control Cable (supplied). Batteries installation is required when using as Wired Remote Control Unit.
REMOTE CONTROL BATTERIES INSTALLATION
1
Remove the battery
compartment lid.
OPEN
Press the lid
downward
and slide it.
To insure safe operation, please observe the following precautions :
Use (2) AA, UM3 or R06 type alkaline batteries.
Replace two batteries at the same time.
Do not use a new battery with a used battery.
Avoid contact with water or liquid.
Do not expose Remote Control Unit to moisture, or heat.
Do not drop Remote Control Unit.
If batteries have leaked on Remote Control Unit, carefully wipe the case clean and load new
batteries.
WIRED REMOTE CONTROL OPERATION
Remote Control Cable (supplied)
2
Slide 2 batteries into
the compartment.
Two AA size batteries
For correct polarity (+ and –), be sure
the battery terminals are in contact
with pins in the compartment.
BEFORE OPERATION
INPUT 1
R/C JACK
3
Replace the compartment
lid.
OPEN
Slide the lid
upward.
17
Advertisement
Table of Contents
