Setting-Up Projector; Connecting Ac Power Cord - Sanyo PLV-60HT Owner's Manual

PREPARATION
This projector uses nominal input voltages of 100-120 V
or 200-240 V AC. The projector automatically selects the
correct input voltage. It is designed to work with single-
phase power systems having a grounded neutral
conductor. To reduce the risk of electrical shock, do not
plug into any other type of power system.
Consult your authorized dealer or service station if you
are not sure of the type of power supply being in use.
Connect projector with the peripheral equipment before
turning projector on. (Refer to pages 11 ~ 13 for
connection.)
CAUTION
For safety, unplug the AC Power Cord when the
appliance is not used.
NOTE ON THE POWER CORD
The AC Power Cord must meet the requirement of the country where you use the projector.
Confirm the AC plug type with the chart below. The proper AC power cord must be used.
If the supplied AC Power Cord does not match the AC outlet, contact your sales dealer.
Projector side
8

SETTING-UP PROJECTOR

CONNECTING AC POWER CORD

For the U.S.A. and Canada
To the POWER CORD
CONNECTOR on the
projector.
Connect AC Power Cord (supplied) to
projector.
The AC outlet must be near this
equipment and must be easily
accessible.
AC Outlet side
For Continental Europe
Ground
To the AC Outlet.
(120 V AC)
MAIN ON / OFF SWITCH
To the AC Outlet.
(200 - 240 V AC)