Hilti Nuron TE 60-22 Original Operating Instructions page 17

6 Operation
Observe the safety instructions and warnings in this documentation and on the product.
6.1 Switching on
1. Press the on/off switch.
2. Then press the control switch.
6.2 Function selector switch
▶ Set the function selector switch to the desired working position.
▶ Do not operate the function selector switch while the motor is running. Risk of damage!
6.2.1 Drilling with hammering action (hammer drilling)
▶ Set the function selector switch to:
6.2.2 Drilling without hammer action
Drilling without hammering action is possible when accessory tools with a special connection end
are used. Accessory tools of this kind are available from Hilti. Alternatively, when the keyless quick-
release chuck is fitted, smooth-shank drill bits for wood or steel, for example, can be used to drill
without hammering.
▶ Set the function selector switch to:
6.2.3 Chisel positioning
CAUTION
Risk of injury! Loss of control over the chisel direction.
▶ Do not operate the tool when the selector switch is set to "Chisel positioning". Turn the function selector
switch until it engages in the "Chiseling" position.
The chisel can be set to 24 different positions (in 15° increments). This ensures that flat chisels and
shaped chisels can always be set to the optimum working position.
1. Set the function selector switch to:
2. Turn the chisel to the desired position.
3. Set the function selector switch to:
▶ The product is ready for use.
6.2.4 Chiseling
▶ Set the function selector switch to:
6.3 Switch sustained operation on and off
When chiseling, the control switch can be locked in the "on" position.
1. Push the lockbutton for continuous operation forward.
2. Press the on/off switch.
3. Then press the control switch all the way down.
▶ The product then runs in sustained operating mode.
4. Push the lockbutton for continuous operation back.
▶ The product switches off.
*2267488*
7
.
.
7
.
until it engages.
.
8
2267488 English 11