Hilti Nuron TE 60-22 Original Operating Instructions page 16

5.5 Fitting the depth gauge (optional)
1. Release the side handle clamping band by turning the handle grip.
2. Release the side handle by turning the knob until the clamping band is slack.
3. Slide the depth gauge from the front into the 2 guide holes provided.
4. Secure the side handle by turning the knob until the clamping band is tight.
5. Tighten the side handle clamping band by turning the handle grip.
5.6 Setting the power level
After the battery is inserted, the product is always set by default to full power.
1. Press the "button for half power". The product runs at half power.
▶ The "half power indicator" lights up.
2. Press the "button for half power" again. The product runs at full power.
▶ The "half power indicator" goes out.
5.7 Inserting / removing the accessory tool
DANGER
Risk of fire! Risk of contact between the hot accessory tool and highly inflammable materials.
▶ Do not lay the hot accessory tool down on highly inflammable materials.
CAUTION
Risk of injury by the accessory tool! The accessory tool might be hot or have sharp edges.
▶ Wear protective gloves when changing the accessory tool.
The use of unsuitable grease can cause damage to the product. Use only genuine Hilti grease.
1. Apply a little grease to the connection end of the accessory tool.
2. Push the accessory tool into the chuck as far as it will go (until it engages).
3. After fitting the accessory tool, grip it and pull it in order to check that it is securely engaged.
▶ The product is ready for use.
4. Pull the chuck ring back as far as it will go and remove the accessory tool.
5.8 Fall arrest 6
WARNING
Risk of injury by falling tool and/or accessory!
▶ Use only the Hilti tool tether recommended for your product.
▶ Prior to each use, always check the attachment point of the tool tether for possible damage.
Comply with the national regulations for working at heights.
As drop arrester for this product, use only the Hilti tool tether #2261971.
▶ Use the loop to secure the tool tether to the product as shown in the illustration. Check that it holds
securely.
▶ Secure the carabiner to a load-bearing structure. Check that the carabiner holds securely.
Comply with the operating instructions of the Hilti tool tether.
10 English
4
5
2267488
*2267488*