Furniture Mounting - Extron electronics MTP SW6 User Manual

Installation and Operation, cont'd
1U Universal Rack Shelf
Figure 2-2 — Mounting the MTP SW6 on a 1U, 9.5"
deep universal rack shelf
MTP SW6 • Installation and Operation
2-4

Furniture mounting

For furniture mounting, do not attach the rubber feet. Furniture
mount the switcher using the optional MBU 125 under desk
mounting kit (part #70-077-01) as follows:
1. Remove feet from the bottom of the MTP SW6 if installed.
2. Attach the furniture mounting brackets to the switcher
with the four machine screws supplied with the mounting
kit (figure 2-3).
Figure 2-3 — Attaching the furniture mounting
brackets to an MTP SW6
3. Hold the switcher with the attached brackets against the
underside of the mounting surface. Mark the location of
the bracket's screw holes on the surface.
4. Drill 3/32" (2 mm) diameter pilot holes, 1/4" (6.3 mm)
deep in the mounting surface at the marked locations.
5. Insert #8 wood screws into the four pilot holes. Tighten
each screw into the mounting surface until just less than
1/4" of the screw protrudes.
6. Align the mounting screws with the slots in the brackets
and place the switcher against the surface, with the screws
through the bracket slots.
7. Slide the switcher slightly forward or back, then tighten all
four screws to secure the unit in place.
MTP SW6 • Installation and Operation 2-5