Table of Contents
Advertisement
Always disconnect the pruning shears from the power cord when handling
for other purposes than pruning.
Changing the blade
1.
Using the tool cross tip, unscrew the 2 screws
2.
Using the tool hex tip, remove the screw
3.
Using the tool, remove the nut
4.
Remove the blade (7). Replace the blade.
5.
If necessary, clean around the pinion (warning: do not use chemicals).
6.
Fit the new blade on the pruning shears in the closed position.
7.
Fit the needle stop
triggered (see page 30).
8.
Fit the elastomer washer
9.
If necessary, lubricate the blade teeth using graphite grease.
10. Fit the cover
(2)
11. Adjust the blade overlap if necessary (see "Blade overlap" section on page 18).
12. Lubricate as indicated on p32.
Cleaning and disinfecting the cutting head
It is also possible to clean and/or disinfect the cutting head to prevent any diseases spreading
on the wood. To do that, we recommend avoiding the use of corrosive products that could
damage the device. Do not hesitate to contact INFACO for the choice of products to be
used.
(5)
and the needle stop (6).
(6)
then screw and adjust the nut
(4)
on the screw
on the pruning shears and screw in the 2 screws (1).
(7)
(6)
(1)
and remove the cover (2).
(3)
and the elastomer washer (4).
(5)
tightening until the tool is
(3)
and screw in the screw (3).
(5)
(4)
(3)
(2)
(1)
CLICK!
33
Advertisement
Table of Contents
