Table of Contents
Advertisement
Always disconnect the pruning shears from the power cord when handling
for other purposes than pruning.
Lubrication
Lubricate at least twice per day (early morning and early afternoon).
For correct lubrication the pruning shear blade must be unlocked. To do that:
1.
Use the tool to unblock the bolt and the nut.
2.
Place the greaser tip in the lubricating cap channel. Hold the greaser upright and
activate the pump.
3.
Once lubrication is complete, adjust the tightening of the nut until the tool is triggered.
4.
Block the screw and then check using the correct blade tightening procedure (see below).
Blade tightening
Check the blade tightening every morning.
A well tightened blade should not move
from left to right.
To adjust the tightening
1. Use the tool to unblock
the bolt. You do not need
to remove the bolt.
Note: It is possible to have a slight gap in the blade closure direction. This gap is normal, it
is the gap between the rack and pinion teeth.
32
1
4
CLICK!
To obtain good blade tightening, it must be
possible to close the pruning shear by hand
without forcing (pruning shear power sock-
et disconnected).
2. Unlock and then adjust
the nut tightening until
the tool is triggered.
CLICK!
2
3
3. Block the screw and then
check the tightness using
the previous procedure.
Advertisement
Table of Contents
