Table of Contents
Advertisement
Charger safety
Temperature fault: Status LED
1.
Disconnect the battery and wait a few minutes for the
battery to cool.
2.
Reconnect the battery to the charger cable. If the
problem persists, contact your approved INFACO dealer.
Defective battery: Status LED
1.
Disconnect the battery from the charging cable.
2.
Check that the battery and charger contacts are clean
and in good condition, then reconnect the battery to
the charger cable.
3.
If the problem persists, disconnect the defective battery
from the charger cable and contact your approved
INFACO dealer.
Please remember that the INFACO Lithium charger (Ref.: 941C) is only for use with
F3020 Lithium batteries (Ref: L100B). This charger is not suitable for other batteries.
(1)
flashes red
(1)
steady red
17
Advertisement
Table of Contents
