Bending Wire; Maintenance/Lubrication; Optional Accessories; Replacement Parts - Jet SBR-30N Operating Instructions And Parts Manual

Bending Wire

There are three wire grooves at the end of the
press rollers to accommodate a 1/8", 3/16" and
a 1/4" wire.
Use the smallest groove into which the wire will
comfortably fit. Bend the wire using the same
principles as described for forming a radius. To
make a complete loop of wire, use the
instructions for forming a tube.

Maintenance/Lubrication

Use caution when doing
maintenance work around
the shear blades.
1. Apply #2 lithium tube grease once a month
to the grease nipples on both ends of the
frame (Figure 17).
2. Keep the slip rolls clean and rust-free, and
frequently apply a light coat of oil to them.
3. Lightly brush a multi-purpose grease onto
the gears at the end of the rollers (Figure
17). Turn the operating handle to distribute
the grease.
4. Keep other exposed areas clean and lightly
coated with oil, such as the shear blades,
table and upper dies. (Remove the upper
dies from the bar for more effective
cleaning).

Optional Accessories

Part No. Description
754030 Optional Stand for SBR-30N
754040 Optional Stand for SBR-40N

Replacement Parts

Replacement parts are listed on the following pages. To order parts or reach our service department, call
1-800-274-6848, Monday through Friday (see our website for business hours, www.waltermeier.com).
Having the Model Number and Serial Number of your machine available when you call will allow us to
serve you quickly and accurately.
Figure 17
Optional Stand
12