Poi Permanent Outdoor Installation; Physical Differences; Configuration; Led Indicator - SGM P Series User Manual

E

POI Permanent Outdoor Installation

The SGM POI versions are designed for permanent outdoor installation and are IP66-rated. POI versions are designed for use in
maritime and offshore environments, as per the CX/C5-M corrosion-resistance class.

Physical differences

The POI version differs from the standard version by having fixed-chassis power and DMX cables, and heavy-duty cable glands. The
display and control panel have been removed.

Configuration

The P-2 POI does not include a display, therefore it has to be configured through RDM (Remote Device Management). See "RDM"
on page 15 for more information.
In P-2 POI, the DMX address and DMX mode can only be set through RDM. When addressing through USB powered DMX/ RDM
devices, ensure DMX link is terminated, and keep a short cable length as much as possible.
Regarding the DMX modes for POI, they are the same as the P-2 standard. Visit www.sgmlight.com to see all DMX charts available
under the respective product, or upon request via support@sgmlight.com.
PLEASE NOTE!
Remote Device Management (RDM) requires fully compliant DMX cable to be installed and terminated.
When setting addresses through RDM and using USB dongles, disable the USB selective suspend to ensure a proper
voltage on the DMX link. If any lag or trouble occurs when addressing, decrease the cable length range to <12 m. and only
address one fixture at a time.

LED Indicator

The LED indicator is located on the fixture's head (same place where the display is located in
standard P-2), and shows the current status of the fixture.
The LED indicator has three different colors and three possible stages: static, flashing, or off.
• Solid Orange: fixture is starting up.
• Blinking Green: wireless and/ or wired DMX connected.
• Solid Green: no wireless or wired DMX connection.
• Blinking Red: wireless and/ or wired DMX connected but Error(s) occurred.
• Solid Red: no wireless or wired DMX connection but Error(s) occurred.
• Off: fixture is off or indicator LED is set to auto dimming (set via RDM).

SGM Addressing Tool

SGM provides a Windows software tool designed to allow the user to address and configure the fixtures through RDM. Changing the
settings is done in the exact same way as it is in the display.
This tool is available for download at www.sgmlight.com, and has to be used with the SGM USB 5-Pin-XLR Uploader cable POI if
the luminaire does not use XLR connectors in the DMX cable, or the SGM USB uploader cable if the luminaire uses XLR 5-pin DMX
connectors (available from your SGM dealer).
16
K
Figure 15: SGM Addressing tool
I
L
Figure 14: P-2 POI LED indicator