Installation; Access To The Internal Components; Mounting The Lamps - SGM Idea spot 575 User Manual

1.0 – Installation
1.1 – Access to the internal components
It is possible to inspect the inside of the projector by removing the cover as indicated below.
ATTENTION! remove mains power prior to accessing the projector's internal
components.
1. Loosen the screws which fix the upper and lower covers (photo 1) and unscrew the side covers
(photo 2).
2. Once unscrewed, simply lift the covers to access the internal components (photo 3).
photo 1

1.2 - Mounting the lamps

Warning: turn power off before opening the appliance.
Philips 575 MSR/2
Power 575W
Luminous flux 49,000 lm
Colour temperature 7.200°K
Lampbase GX9,5
Rated life 1,000 hours
1. Using a head screwdriver, remove the 3 screws (X,Y, Z) (photo 1, black screws) which hold the
lampholder in place and are located at the rear of the projector head.
Photo 1
2. Remove the lampholder unit. Locate the lampholder (photo 2).
3. Insert the lamp (photo 3).
4. The lamp used is manufactured from quartz glass and should be handled with care. Always adhere
to the instructions supplied in the lamp's packaging. Never touch the glass directly but use the tissue
provided in the lamp's packaging. The GX 9.5 lampbase is symmetrical.
GB
photo 2
Photo 2
6
photo 3
Photo 3
Idea Spot 575 rel. 1.0
Photo 4