Advertisement
Slot three carcass cams
(M) into the large holes
in the underside of the
B
top back section (12).
Note: Carcass cams have
a narrower head than
Q
the drawer cams (B)
13
supplied in the fittings
12
pack.
Tighten the carcass cams
using a flat-head
screwdriver.
Insert two carcass cams
(M) into the large holes
in the rear face of the
back changing rail (13).
Do no tighten the cams.
Attach the wall strap (Q)
to the rear face of the
changing back rail using
the screw and washer
supplied.
With the help of another
13
person, lift the dresser
upright.
Align the cam studs in
15
the left and right
changing rails (15&16)
and the dowels in top
back section (12), back
16
changing rail (13) and
the front changing rail
(14) with relevant holes
and slot them together.
14
Tighten the two carcass
cams in the back of the
back changing rail (13)
using a flat-head
screwdriver.
Screw in six assembly
bolts (P) through the
holes in the left and
right changing rails
(15&16) and tighten
P
them into the top using
R
the allen key (R).
PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor
– 18 –
Advertisement
