Mounting The Loop Handle; Fuel - Stihl KombiEngine ECOSPEED KM 94 R Instruction Manual

5 Mounting the Loop Handle

5 Mounting the Loop Handle
A barrier bar is supplied with the machine. Fit the
barrier bar on the loop handle.
2
► Fit the square nuts (1) in the barrier bar (2);
the holes must line up.
4
5
6
7
► Place the clamp (3) in the loop handle (4) and
position them both against the drive tube (5).
► Position the clamp (6) against the drive tube.
0458-467-8321-C
1
1
2
3
► Place the barrier bar (2) in position as shown.
► Line up the holes.
► Insert the screws (7) in the holes and screw
them into the barrier bar (2) as far as stop.
► Go to "Adjusting and Securing the Loop Han‐
dle".
5.1 Adjusting and Securing the
Loop Handle
A
The loop handle can be adjusted to suit the
height and reach of the operator and the applica‐
tion by changing distance (A).
Recommendation: distance (A): about 22 cm
(8.7 in)
► Slide the handle to the required position.
► Line up the loop handle (4).
► Tighten down the screws until the loop handle
can no longer be rotated on the drive tube. If
no barrier bar is fitted – lock the nuts if neces‐
sary.
Leave the barrier bar permanently mounted to
the loop handle.
6

Fuel

The engine requires a mixture of gasoline and
engine oil.
English
4
7