English
8.1.2
Function of Throttle Set Wheel
The throttle set wheel (4) enables the travel of
the throttle trigger to be preset anywhere
between idle and full throttle.
– Turn throttle set wheel (4) in direction of – to
reduce throttle trigger travel and maximum
engine speed.
– Turn throttle set wheel (4) in direction of + to
increase throttle trigger travel and maximum
engine speed.
– It is possible to override the preset stop and
open the throttle wide by pulling the throttle
trigger firmly – the preset stop remains unaf‐
fected. The original setting is restored when
the throttle trigger is released.
8.2
Starting the Engine
► Press the manual fuel pump bulb (5) at least
five times – even if the bulb is already filled
with fuel.
► Turn throttle set wheel in direction of + as far
as stop.
10
4
5
8 Starting / Stopping the Engine
Cold engine (cold start)
6
► Turn choke knob (6) and then push it in at g
Also use this setting if the engine has been run‐
ning but is still cold.
Hot engine (hot start)
► Choke knob (6) remains in F position.
8.2.1
Cranking
► Place the power tool on the ground so that it
rests on the machine support:
► If fitted: Remove the transport guard from the
cutting attachment.
To reduce the risk of accidents, check that the
working tool is not touching the ground or any
other obstacles – see also "Starting / Stopping
the Engine" in the KombiTool instruction manual.
► Make sure you have a firm footing, either
standing, stooping or kneeling.
► Hold the unit firmly on the ground with your left
hand and press down – do not touch the throt‐
tle trigger, lockout lever or stop switch.
1.
2.
0458-467-8321-C