Table of Contents
Advertisement
1.
UNDER CABINET INSTALLATION
a.
Make sure all preparation steps are completed.
b.
Feed the wires coming out of the hood through the bottom of the cabinet.
c.
Lift the unit up flush against the wall and the bottom of the cabinet.
d.
Using the screws and washers provided, insert into each of the keyhole
openings and tightly secure the unit against the bottom of the cabinet.
NOTE: Install more screws through the back of the unit if necessary.
e.
Use the conversion collar for 7" ducting. (OPTIONAL)
f.
Connect 7" ducting to the collar of the hood.
g.
Finish off by sealing the connection points with aluminum tape.
2.
COLD WEATHER INSTALLATION (OPTIONAL)
a.
Check with your local building codes to see if a CFM reducer is an
acceptable alterative to make-up air.
b.
Remove the WS-55CFMR (CFM Reducer) and inspect for any sign of
defect or damage. (ie. Cracks, broken flips)
AFTER COMPLETING Step A-D of Section 1 UNDER CABINET
c.
INSTALLATION.
d.
Place the CFM reducer onto the outlet of the unit and seal the connection
point with aluminum tape. (Be sure it is secure with no opening or gaps)
e.
Connect a 7" ducting to the collar of the CFM reducer.
f.
Finish off by sealing the connection points with aluminum tape.
NOTE: If using CFM reducer, you must connect the reducer to the unit
before continuing.
INSTALLATION
INSTALLATION
Advertisement
Table of Contents
