Table of Contents
Advertisement
8
INSTALLATION
1. DUCTED INSTALLATION
**DO NOT INSTALL CLOSER THAN 29" ABOVE COOKING SURFACE**
a.
Make sure all preparation steps are completed.
b.
Determine where you would like to mount the hood.
c.
Refer to diagram on page 9 to remove lower panel for installation.
d.
Lift the unit up flush against the wall.
e.
Be sure the unit is leveled and parallel.
f.
Using the screws and washers provided, tightly secure the unit against
the wall and the cabinet frame.
NOTE: Install additional screws through the back of the unit if necessary.
g.
Use the conversion collar for 7" ducting. (OPTIONAL)
h.
Connect 6" or 7" ducting to the collar of the hood.
i.
Finish off by sealing the connection point with aluminum tape.
2. COLD WEATHER INSTALLATION (OPTIONAL)
NOTE: WS-69CFMR is only compatible with 6" top round outlet
a.
Check with your local building codes to see if a CFM reducer is an
acceptable alternative to make-up air.
b.
Remove the WS-69CFMR (CFM Reducer) and inspect for any sign of
defect or damage. (i.e. Cracks, broken/defective sections)
c.
AFTER COMPLETING Step A – E of Section 1 DUCTED
INSTALLATION (Top round outlet)
d.
Place the CFM reducer onto the outlet of the unit and seal the connection
point with aluminum tape. (Be sure it is secured with no opening or gaps)
e.
Connect a 6" ducting to the collar of the CFM reducer.
f.
Finish off by sealing other connection points with aluminum tape.
Installation diagram available on next page
Advertisement
Table of Contents
