Preparation; Installation - Windster RA-7636SS User Manual

6

PREPARATION

PREPARATION
1.
BEFORE YOU START
**BE SURE YOUR UNIT WILL FIT YOUR CEILING HEIGHT**
**DO NOT INSTALL IF DAMAGED**
**RETURN OR EXCHANGE WILL BE DENIED IF INSTALLED**
a. Be sure you have all the content of your purchase and required tools for
this installation.
b. Installation may take at least 2 to 3 hours from start to finish.
c. Plan to use as few elbows or turns as possible for more efficient air flow.
d. Collar size may need to be increased if utilizing a long duct run.
e. Turns must be made after passing ceiling.
f. Do not try to install this unit by yourself, SERIOUS INJURY MAY OCCUR.
g. At least two people are needed for installation.
h. Hiring a certified installer and electrician is recommended.
2.
LOCATION
**THIS MODEL MAY NOT FIT ALL CEILING HEIGHTS**
a. Determine the exact location you where want to install the range hood.
b. Distance between cooktop and range hood should be between 27"-33".
c. Range hood should be mounted at stated measurements to ensure
performance and lifespan of electrical components.
d. Correctly measure the dimension needed to install the unit.
3.
HOOD
a. Inspect for any sign of defect or damage. (ie. scratches, dents, loose
seams, etc.)
b. Power up the unit to make sure it is working properly.
Use Fig. 1a and 1b on page 5 for measurements
``
1. STANDARD INSTALLATION
a. Make sure all preparation steps are completed.
b. Determine your ceiling height to see if you need an extension.
i. Hood unit height = 12"
ii. Standard DC height = 15-3/4" (lower) + 17" (upper)
iii. Minimum height (Standard duct cover only) = 20-1/2"
iv. Minimum height (Standard duct cover w/ DK) = 21-5/8"
v. Maximum height (Standard duct cover only) = 31-3/4"
vi. (OPTIONAL) RA-76ExtDC Minimum height = 31-5/8"
vii. (OPTIONAL) RA-76ExtDC Minimum height w/ DK = 33-1/4"
viii. (OPTIONAL) RA-76ExtDC Maximum height = 54-1/2"
ix. Standard Installation = Hood + standard DC
x. Long Installation = Hood + RA-76ExtDC
c. Determine the location you want to install the range hood. (Fig. 2a)
d. Prepare ceiling and locate wood support.
e. Use stencil to guide the support frame installation.
f. Mount the unit upper support frame to the ceiling.
g. Cut a 6" or 7" round opening at the ceiling for ducting pipe.
h. Attach upper duct cover to the upper support frame using 4 screws.
i. Insert lower support frame to the upper support frame.
j. Adjust the lower support frame to your desired height. (Fig. 2b)
k. Use a spirit level to ensure the balance of the support frame is true.
l. Slide lower duct cover into the support frames and secure with screws.
m. Install ducting through the ceiling.
n. Secure hood from the bottom by using the (8) screws provided. (Fig. 2c)
o. Connect piping to the outlet of the hood.
p. Installation is complete when hood is securely in place. (Fig. 2d)
``

INSTALLATION

INSTALLATION
7