Page 1
USER GUIDE MATP0412 VitalBase watch - VBC3 Alarm Button After removing VitalBase from its package, fully read the documentation before performing the following steps. Step N°1 : Sleep mode Exit The red led lights up Push the button for 3 seconds Immediately release the button Step N°2 : Verification of normal operation If this step does not take place correctly start again with step N°1...
Page 2
MATP0412 Step N°3 : Enter sleep mode VitalBase watch needs to lay down on the table during this step as shown on this picture Press and release the button just like for sending an alarm While led is on, press and release the button 5 times quickly Holding the last 5th press until the led turns off.
Need help?
Do you have a question about the VitalBase VBC3 and is the answer not in the manual?
Questions and answers