Output Submenu - Dsc 3G-Hd A - Extron electronics DSC 3G-HD A User Manual

Film Mode — This item lets you enable and disable Film Mode. After selecting the
•
item, press any arrow button to toggle between Auto (the default) and Off.
If Auto is selected, the DSC detects:
• 3:2 pull-down for NTSC and 1080i @ 60 Hz
• 2:2 and 24:1 pull-down for PAL and 1080i @ 50 Hz
Active — This view-only field shows the width in pixels (the H value) and the height in
•
lines (the V value) of the active video area.
Total — This view-only field shows the width in pixels (the H value) and the height in
•
lines (the V value) of the total video display area.
• Start — This view-only field shows the distance in pixels from the left edge of the
total video display to the left edge of its active area (H value) and the distance in lines
from the top edge of the total video display to the top edge of its active area.
Output Submenu — DSC 3G-HD A
This submenu allows you to configure the output of the DSC 3G-HD A.
NOTE: The DSC 3G-HD A has some different items on this submenu from
DSC HD-3G A (see
Figure 17.
• Output Resolution — This item lets you select the resolution and refresh rate for
the connected output display. The DSC 3G-HD A has a range of resolutions from
which to choose (see the
table on the next page for the settings that are available for this model). The available
refresh rates depend on the selected resolution.
Select Output Resolution from the Output submenu.
1.
2. Press the t or  button to select a resolution.
Output Submenu — DSC HD-3G A
Output Submenu — DSC 3G-HD A
Resolutions and Refresh Rates for the DSC 3G-HD A
DSC 3G-HD A and DSC HD-3G A • Operation
on page 26).
24