Table of Contents
Advertisement
2.4 Hanging belt
Before hanging belt, ALWAYS turn the power switch OFF
and check that the machine has already stopped.
Use the M-type of V-belt.
(1) Hang the belt ① on the machine pulley ② , and then
on the motor pulley ③ while rotating the machine
pulley.
(2) Adjust the belt tension so that the belt has a slack of
10 - 20 ㎜ when its center is pushed with 10 N.
(3) Lock the motor with the adjusting bar ④ .
2.5 Belt cover
Set the belt cover ⑤ . (Fig. 2-15)
2.6 Thread guide plate
(1) Put the screws ⑥ into the hole
guide plate ⑦ and push it to the left.
(2) Fix the thread guide plate ⑦ with the screws ⑥
securely.
②
Fig. 2-14
Fig. 2-15
of the thread
Fig. 2-16
9
2. Installation
①
10 - 20 ㎜
④
⑥
③
⑤
⑦
VFK2560-8
Advertisement
Table of Contents
