Hanging Belt; Belt Cover - Yamato VG3511-8F Instruction Manual

2. Installation

2.4 Hanging belt

Before hanging belt, ALWAYS turn the power switch OFF
and check that the machine has already stopped.
Use the M-type of V-belt.
(1) Hang the belt ① on the machine pulley ② , and then
on the motor pulley ③ while rotating the machine pul-
ley.
(2) Adjust the belt tension so that the belt has a slack of
10 - 20 ㎜ when its center is pushed with 10 N.
(3) Lock the motor with the adjusting bar ④ .

2.5 Belt cover

Be sure to install belt cover to prevent you from injuring
and a material from being caught by the belt.
(1) Install the belt cover ⑤ . (Fig. 2-7)
(2) Push the belt cover support ⑥ to the belt cover ⑤ to
install it.
(3) Fix the belt cover(lower) ⑦ on the machine table. (Fig.
2-9)
⑤
Fig. 2-8
VG3511-8F
see from back
side of machine
⑥
6
②
10 - 20 ㎜
④
Fig. 2-6
Fig. 2-7
Fig. 2-9
①
③
⑤
⑦