Regulator Installation - Wolf CG Series Service Manual

REMOVE ALL BURNER ASSEMBLIES (continued)
4 Remove the burner assembly from the unit.
Remove the Burner Pan
Lift the burner pan from the burner box.
Remove the Regulator
1 Disconnect the external gas supply line to the inlet of the
1
regulator from the / " NPT nipple.
2
5
2 Use a / " combination wrench to remove the regulator
8
outlet line from the brass fitting.
1
3 Use a / " combination wrench to remove the retaining nut
4
from the regulator bracket.
4 Remove the regulator and regulator bracket from the unit.
828386 REV. A 06/2018
CG Professional Gas Cooktop Service Manual
Burner Cap
Burner Assembly
Igniter
Electrode Wire
7
5 Use a / " box wrench to remove the brass fitting from the
8
regulator outlet.
TIP: The regulator is identified as liquid propane (LP) by its red
cap.

REGULATOR INSTALLATION

Install the Regulator
7
1 Use a / " box wrench to install the brass fitting onto the
8
regulator outlet.
2 Place the regulator and regulator bracket in the unit.
1
3 Use a / " combination wrench to install the retaining nut
4
into the regulator bracket.
5
4 Use a / " combination wrench to install the regulator outlet
8
line onto the brass fitting.
5 Connect the external gas supply line to the
on the inlet of the regulator.
WARNING
Only pipe thread compound should be used. Do not
use Teflon tape to seal gas connections.
Install the Burner Pan
Place the burner pan on the burner box.
Install All Burner Assemblies
To install each burner assembly:
1 Attach the electrode wire to the igniter.
2 Place the burner assembly into the burner pan.
3 Use a T-15 Torx bit to install the screws holding the burner
assembly to the orifice holder, torqued to 24 in lb.
22
service.subzero.com
1
/ " NPT nipple
2