Regulator Installation - Wolf CG365P/S Manual

Remove the Burner Pan
Lift the burner pan from the burner box.
Remove the Regulator
1 Disconnect the external gas supply line to the inlet of the
1
regulator from the / " NPT nipple.
2
5
2 Use a / " combination wrench to remove the regulator
8
outlet line from the brass fitting.
1
3 Use a / " nut driver to remove the screws from the
4
regulator bracket.
4 Remove the regulator and regulator bracket from the unit.
7
5 Use a / " box wrench to remove the brass fitting from the
8
regulator outlet.
TIP: The regulator is identified as liquid propane (LP) by its red
cap.

REGULATOR INSTALLATION

Install the Regulator
7
1 Use a / " box wrench to install the brass fitting onto the
8
regulator outlet.
828389 REV. A 06/2018
CG Contemporary Gas Cooktop Service Manual
2 Place the regulator and regulator bracket in the unit.
3 Use a
bracket.
4 Use a
line onto the brass fitting.
5 Connect the external gas supply line to the
on the inlet of the regulator.
Only pipe thread compound should be used. Do not
use Teflon tape to seal gas connections.
Install the Burner Pan
Place the burner pan on the burner box.
Install All Burner Assemblies
To install each burner assembly:
1 Attach the electrode wire to the igniter.
2 Place the burner assembly into the burner pan.
3 Use a T-15 Torx bit to install the screws holding the burner
assembly to the orifice holder, torqued to 24 in lb.
Install the Unit
Install the unit.
Install All Bezels
To install each bezel:
1 Insert the bezel into the unit.
2 Use a
Install All Knobs
Push each knob onto each valve shaft.
Install All Burner Caps
Install all burner caps onto the burner assemblies.
26
1
/ " nut driver to install the screws into the regulator
4
5
/ " combination wrench to install the regulator outlet
8
WARNING
3
/ " socket to install the bezel on the unit.
4
service.subzero.com
1
/ " NPT nipple
2