Manifold Removal - Wolf CG Series Service Manual

Install All Bezels
To install each bezel:
1 Connect the bezel to the light wire harness.
2 Insert the bezel into the unit.
3 Twist the bezel 90° clockwise.
Install All Knobs
Push each knob onto each valve shaft.
Install All Burner Caps
Install all burner caps onto the burner assemblies.
Install All Burner Grates
Place all burner grates onto the cooktop.

MANIFOLD REMOVAL

To remove the manifold, first remove the burner grates and
burner caps. Uninstall the unit, and then remove the knobs,
bezels, burner assemblies, burner pan, receptacles, and burner
valves.
TIP: It is unnecessary to remove gas lines or switch wiring from
burner valves to replace the manifold.
WARNING
Turn off the power and gas to the product before
starting this procedure.
CAUTION
If the gas line is not long enough to stay connected
when the unit is pulled out of the opening, the gas
may need to be disconnected.
828386 REV. A 06/2018
CG Professional Gas Cooktop Service Manual
Remove All Burner Grates
Lift all burner grates from the unit.
Remove All Burner Caps
Remove all burner caps from the burner assemblies.
Uninstall the Unit
Remove the unit from the installation.
23
service.subzero.com