Wolf CG Series Service Manual page 15

Remove All Knobs
Pull all of the knobs away from the unit.
Remove All Bezels
To remove each bezel:
1 Twist the bezel 90° counterclockwise.
2 Pull the bezel from the pan.
3 Disconnect the bezel from the light wire harness.
4 Remove the bezel from the unit.
Remove All Burner Assemblies
To remove each burner assembly:
1 Use a T-15 Torx bit to remove the screws holding the burner
assembly to the orifice holder.
2 Lift the burner assembly from the burner pan.
3 Remove the electrode wire from the igniter.
828386 REV. A 06/2018
CG Professional Gas Cooktop Service Manual
4 Remove the burner assembly from the unit.
Remove the Burner Pan
Lift the burner pan from the burner box.
Remove the Orifice Holder
CAUTION
Do not lift the manifold to remove the tube fittings.
Gas tubes provide support to the manifold.
Deforming the gas tube may cause knob alignment
issues.
1 Use a
line.
2 Use a
14
Burner Cap
Burner Assembly
Igniter
Electrode Wire
3
/ " combination wrench to remove the simmer gas
8
1
/ " combination wrench to remove the main gas line.
2
service.subzero.com