Wolf CG Series Service Manual page 11

REMOVE ALL BEZELS (continued)
4 Remove the bezel from the unit.
Remove All Burner Assemblies
To remove each burner assembly:
1 Use a T-15 Torx bit to remove the screws holding the burner
assembly to the orifice holder.
2 Lift the burner assembly from the burner pan.
3 Remove the electrode wire from the igniter.
4 Remove the burner assembly from the unit.
Igniter
828386 REV. A 06/2018
CG Professional Gas Cooktop Service Manual
Burner Cap
Burner Assembly
Electrode Wire
Remove the Burner Pan
Lift the burner pan from the burner box.
BURNER PAN INSTALLATION
Install the Burner Pan
Place the burner pan on the burner box.
Install All Burner Assemblies
To install each burner assembly:
1 Attach the electrode wire to the igniter.
2 Place the burner assembly into the burner pan.
3 Use a T-15 Torx bit to install the screws holding the burner
assembly to the orifice holder, torqued to 24 in lb.
Install All Bezels
To install each bezel:
1 Connect the bezel to the light wire harness.
2 Insert the bezel into the unit.
3 Twist the bezel 90° clockwise.
Install All Knobs
Push each knob onto each valve shaft.
Install the Unit
Install the unit.
10
service.subzero.com