Installation; Troubleshooting - Wolf ICBCG152TF/S Installation Manual

Installation

Cooktop Installation
Remove cooktop and components from the shipping
package and recycle packing materials.
Lower the cooktop into the countertop cut-out. Center
cooktop in the opening with the front edge aligned parallel
to the front edge of the countertop. Using a pencil, outline
the rear edge of the cooktop on the countertop. Remove
cooktop.
Apply the foam strip provided, to the perimeter of the
countertop opening. Refer to the illustration below. Do not
seal the cooktop to the countertop.
Insert the cooktop into the opening. Verify the cooktop is
aligned with the front edge of the countertop.
Attach the brackets provided, to the bottom of the unit.
Insert the 89 mm clamping screws into the brackets. Use a
screwdriver to tighten clamping screws against the bottom
of the countertop. Do not overtighten screws. Refer to the
illustration below.
FOAM STRIP
COUNTERTOP
BRACKET CLAMPING
SCREW
Cooktop installation
Sub-Zero, Sub-Zero & Design, Sub-Zero & Snowflake Design, Dual Refrigeration, The Living Kitchen, Great American Kitchens The Fine Art of Kitchen Design, Wolf, Wolf & Design, Wolf Gourmet, W & Design, red colored knobs, Cove, and Cove & Design are registered trademarks and service marks of Sub-Zero Group, Inc. and its subsidiaries.
All other trademarks are property of their respective owners in the United States and other countries.
Gas Supply Connection
All connections to the gas piping must be wrench-tight-
ened. Do not overtighten or allow pipes to turn when
tightening.
If a flexible metal connector is being used, verify it is not
kinked, then attach the gas supply line to the regulator on
the cooktop. Open the valve and check for leaks by plac-
ing a liquid detergent solution onto all gas connections.
Bubbles around connections indicate a gas leak. If a leak
appears, close the shut-off valve and adjust connections.
Burner Grates
610 mm MODEL
For 610 mm models, the grates must be positioned cor-
rectly to ensure proper burner performance. The grates
have an indicator on the bottom of the front edge. Position
the grates with the indicator toward the front of the cook-
top. Refer to the illustration below.
FRONT
Grate placement (610 mm model)

Troubleshooting

Troubleshooting
IMPORTANT NOTE: If the cooktop does not operate prop-
erly, follow these troubleshooting steps:
• Verify electrical power is supplied to the cooktop.
• Verify the gas supply shut-off valve is in the open
position.
• If the cooktop does not operate properly, contact Wolf
factory certified service. Do not attempt to repair the
oven. Wolf is not responsible for service required to
correct a faulty installation.
Efficiency Rating
BURNER EFFICIENCY NATURAL GAS
2.7 kW Burner
3.5 kW Burner
5.3 kW Burner
NOTE: In accordance with EU No. 65/2014 and 66/2014.
wolfappliance.com | 7
55%
55%
55%