Wolf CG Series Service Manual page 18

REMOVE ALL BURNER ASSEMBLIES (continued)
4 Remove the burner assembly from the unit.
Remove the Burner Pan
Lift the burner pan from the burner box.
Remove the Receptacle
1 Use a Phillips screwdriver to remove the mounting screws
from the receptacle.
2 Remove the receptacle from the unit.
828386 REV. A 06/2018
CG Professional Gas Cooktop Service Manual
Burner Cap
Burner Assembly
Igniter
Electrode Wire
Remove the Valve Switch
1 Use a Phillips screwdriver to remove the color-coded screw
from the switch.
2 Lift the switch from the valve.
3 Remove the black wire from the normally-open (NO)
terminal.
4 Remove the red wire from the common (C) terminal.
VALVE SWITCH INSTALLATION
Install the Valve Switch
1 Install the red wire onto the common (C) terminal.
2 Install the black wire onto the normally-open (NO) terminal.
3 Place the switch onto the valve.
4 Use a Phillips screwdriver to install the color-coded screw
onto the switch.
TIP: Do not over-torque the screw when installing the new
switch.
Install the Receptacle
1 Install the receptacle onto the burner valve.
2 Use a Phillips screwdriver to install the mounting screws
into the receptacle.
Install the Burner Pan
Place the burner pan on the burner box.
17
service.subzero.com