Working Interruptions Or Coating Breaks; Switching Off The Plant - Gema MagicControl 4.0 Operating Instructions And Spare Parts List

Working interruptions or coating breaks

Switching off the plant

MagicControl 4.0 (CM40)
Rev. 01 12/21
If the coating process is interrupted for a longer period of time, the system
should be brought into an economical state.
1. Clean the plant, See chapter "Cleaning operation mode" on page 40.
2. To exit Cleaning mode, press and hold the
seconds.
Fig. 28:
3. The display changes to this screen
Fig. 29:
4. Turn the key switch to 0 to turn off the control voltage.
–
The indicator lamp goes out.
key for 2
Operation • 43