User Levels And Access; Functions Available At User Level - Gema MagicControl 4.0 Operating Instructions And Spare Parts List

User levels and access

The panel can be used without any
limitation
Level for specialized Gema staff
Configuration possible
Plant parameters can be modified
Correction values can be modified
Sequence control programs can be
modified
Application parameters can be modified
(axes, guns, pretravel/overtravel, daily
correction)
The user can rename or copy the
existing application data
The user can activate the existing
application data
22 • Product description
Rev. 01 12/21
–
Before every color change
–
Before switching off the plant
The higher the requirement for cleanliness, the higher the time
expenditure will be.
The cleaning of the components is partially automated, however, some of
them must be cleaned manually.
During cleaning, no objects may be present in the booth and no
objects may enter the booth.
The plant control offers the possibility to define the access rights of the
different users. Access is only possible after entering the appropriate
password. Certain functions are available depending on the user level,
which is defined in advance.
The software has 5 user levels as standard predefined by Gema:
–
User level 0 (admin)
–
User level 1 (Gema service)
–
User level 2 (user 1)
–
User level 3 (user 2)
–
User level 4 (user 3)
These user levels are pre-programmed and cannot be changed.
The functions available depending on the user level are explained below.

Functions available at user level

User Admin
User level 0
Administ
User groups
rator









Gema
user 1
Service
1 2
Supervis
Service
or
– –
 –
– –
 
 
 
 
 
 
MagicControl 4.0 (CM40)
user 2 user 3
3 4
Operator Painter
– –
– –
– –
– –
– –
– –
 –
 –
 