superbrightleds WPA-SW Series User Manual

Important: Read all instructions prior to installation.
Selectable CCT Adjustable Angle LED Wall Pack
WPA-SW3B15W-H8DBR35

Wiring Diagram

120–277 VAC Input
Line
L
Neutral
N
Ground
GND

Specifications

Dim (+)
+
Dim (-)
Model
-
Operating Temperature
IP Rating
Dimming

CCT Selection

Field-selectable CCT can be set
using the internal switch as shown.
Make certain supply power is off
when performing this procedure.
Black
L
White
N
Yellow / Green
GND
Purple
+
Pink / Gray
WPA-SW3BxW-H8DBR35
-
-40°–122° F (-40°–50° C)
IP65
0–10 V

Safety and Notes

• Product should be installed and serviced by a certified electrician in accordance
with applicable national, state, and local building and electrical codes.
• To reduce the risk of electric shock, ensure that the main power source and circuit
breakers are switched off before performing any installation or wiring procedures.
Wiring/installation should not be attempted during inclement weather.
• Ensure all mounts are securely attached and will support the weight of the fixture.
Failure to properly support fixture may result in damage or injury, for which the
manufacturer does not assume responsibility.
Line
• Minimum 90° C supply conductors
L
Neutral
N
Ground
GND
0–10 V Dimming
Dim (+)
+
Dim (-)
-
Check product label for specific electrical
specifications related to installation.
Improper installation will void warranty.
Rev Date: V1.0 08/24/2021
4400 Earth City Expy, St. Louis, MO 63045
User Manual
WPA-SW Series
Black
L
White
N
Yellow / Green
GND
Purple
+
Pink / Gray
-
866-590-3533 superbrightleds.com