CAE Apollo User Manual page 40

Step e: Release Pressure from the Trauma Fill Tank
Immediately release pressure from the tank by turning and holding the yellow pressure relief knob
clockwise until all air pressure is gone.
If pressure will not release using the relief knob:
1. Place a rag over the top of the tank and pump handle.
2. While firmly pushing down on the pump handle, slowly turn the handle counter-
clockwise.
NEVER leave a pressurized tank unattended.
Step f: Disconnect the Trauma Fill Tank Umbilical from the Simulator
Disconnect the trauma fill tank umbilical from the simulator and store the assembly out of the way
for later use.
After use, ALWAYS release pressure and clean the tank.
©2021 CAE 905K351052 v1.1
Setup
35