CAE BPDA230-AP User Manual

Peripheral doppler ultrasound training model

Hide thumbs

Table Of Contents

Table of Contents

Quick Links

Download this manual

Table of Contents

Summary of Contents for CAE BPDA230-AP

Page 5: Cautions And Warnings
Electrical Safety • When you unpack your training model, inspect the product and make sure all electronic access ports are sealed shut. If any ports are open or accessible, report this immediately to CAE Blue Phantom Customer Support. • To reduce the risk of electric shock, do not remove the access panel or port cover of models containing electronic components or an automated pumping system.
Page 6 • It is important to use the model and automated pump system only within a temperature range of 0⁰ to 35⁰C (32⁰ to 95⁰F). Avoid any big changes in temperature or humidity, as this can cause condensation to form on or in the automated pump system. ©2022 CAE 905K006452 v1.0...
Page 7: Fluids System
Cautions and Warnings Fluids System • Use only CAE Blue Phantom fluids. Other fluids can affect the imaging quality and promote fungal or bacterial growth, and may void your warranty. Use fluids only as directed. • Do not substitute any other fluid unless indicated by this guide.
Page 9: Introduction
Ultrasound Training Model Anatomy CAE Blue Phantom training models are constructed using our patented Simulex™ ultrasound tissue which has imaging characteristics that mimic human tissue. The models contain skeletal components so the user will encounter the same imaging landmarks as in a human patient.
Page 10: Equipment Overview
The following additional items are required for training but not included in your purchase: • Ultrasound system with appropriate transducer • Ultrasound gel CAE Blue Phantom training models are compatible with any diagnostic ultrasound system. General frequency ranges for diagnostic ultrasound imaging are 2-20MHz. ©2022 CAE 905K006452 v1.0...
Page 11: Using The Training Model
Setup Follow the guidelines below to unpack and set up your CAE Blue Phantom training model. 1. Open the shipping carton: Use extreme caution with sharp tools, such as a box cutter, to avoid damage to the training º...
Page 12: Ultrasound-Guided Procedures
• During use, the user immediately injects any withdrawn fluid back into the model at the access site. • Take care not to inject any air into the model. Note: This model cannot accommodate catheter placements. Use for Doppler ultrasound training and initial venous access only. ©2022 CAE 905K006452 v1.0...
Page 13: Care And Maintenance
With correct use, the model should not require refilling. To maintain the fluid level within the model, reinject any withdrawn fluid during training. This model can be refilled only at the factory. If refilling is necessary, contact CAE Customer Support. Replacing the Inserts Upper and lower arm inserts can be replaced only at the factory.

CAE BPDA230-AP User Manual

Quick Links

Related Manuals for CAE BPDA230-AP

Summary of Contents for CAE BPDA230-AP

Table of Contents