Table of Contents
Advertisement
FenixN – user's manual
Document Revision: 1.5.B50
January 2022
Straight flight: On straight flight, wind will be calculated with use of iterative method which is
based on air speed, ground speed and track measurements.
9.3.3 Influence of wind in final glide
The actual wind data (speed and direction) influences the final glide calculation. In task mode
the final glide indication is based on remaining distance over all TP until finish (not over already
flown turn points). Wind influence for individual legs is based on current wind data.
9.3.4 Event function
User has option to set one of the user inputs to Event. If event switch is pressed during flight, it
will enable faster record interval in flight recorder (recording in shorter intervals as default for a
limited time). Event parameters can be set under Setup / Logger. The action is accompanied
with a clear message.
9.3.5 Task start
Pilot has to ARM first the unit under task page / options. After start line is armed, next crossing
of the line will start navigation to the next point. Task can always be restarted and pilot has also
option to always select point to which he would like to navigate.
9.4 After landing
It is recommended to keep the instrument on for a few minutes after landing. After landing is
detected pilot can see in statistic page a countdown of 5 min before flight will be ended. Pilot
can wait for 5min of press enter to end flight.
Calculating security message will follow and then logbook will be offered to the pilot. At this
point unit can be switched OFF or flight download process can start.
9.4.1 Downloading flights
Insert micro-SD card to the unit. Go to logbook page and search for a flight that you wish to
download. Press lower know on that flight and transfer of flight will start. Progress bar will in-
form pilot when flight is copied to external SD card.
66
Advertisement
Table of Contents
