RC Electronics FenixN User Manual page 52

FenixN – user's manual
3.10.2.2 Zone
Short press with bottom rotary knob will display subpage Zone, where setting for default
parameters of point zone: start, turn point and finish sector can be set.
Selecting any of displayed options, the following list of parameters is displayed.
Turn-point – cannot be modified and is set as default.

Type - describes zones specifications or directions.

o Symmetrical
o Fixed
o To next
o To previous
o To start
A21 – angle between leg and rotation of observer zone

A1 – will determine the zone angle.

R1 – will determine the zone radius.

A2 – will add secondary angle to zone.

R2 – will add secondary radius to zone.

Line – will enable feature only edge border of zone is shown.

With all set parameters, you can now preview zone with selection of View feature.
Zone sub-page reference figure.
51
Document Revision: 1.5.B50
January 2022