Skoda OCTAVIA Workshop Manual page 93

OCTAVIA
Edition 12.98
S00.5103.55.20
Front Suspension
K - Take O-ring seal -arrow- out of groove.
- Mark fitting location of parts 1 ... 3.
1 - Joint
2 - Tripod star
3 - Drive shaft
Notes:
♦ If parts 1 ... 3 are not marked and are not re-
installed in their previous position when as-
sembled, this may result in noise problems
subsequently when driving.
♦ A waterproof felt pen is suitable for marking
the position of the parts.
- Hold joint tight and take drive shaft out of
the vice.
K - Clamp drive shaft in a vice with protective
jaws.
- Remove circlip
1 - commercially available circlip pliers
40
------------ ------------