Skoda OCTAVIA Workshop Manual page 85

OCTAVIA
17 - Thrust ring
♦ fitting location ⇒ page 40-41, Fig. 4
18 - Circlip
♦ replace
♦ insert in the groove on the shaft
Edition 06.05
S00.5103.68.20
Front Wheel Suspension
19 - Outer CV joint
♦ must be replaced completely
♦ removing ⇒ page 40-40, Fig. 1
♦ installing: drive onto the shaft with a
♦ grease ⇒ page 40-62
♦ inspecting ⇒ page 40-45
Disassembling and assembling Tri-
pod joint AAR 2900
Special tools, testers and aids required
⇒ page 40-49
Grease quality and grease quantity
⇒ page 40-62
Disassembling
- Open warm-type clamp on joint part.
- Open warm-type clamp to the drive shaft and
push back joint boot.
- Clamp drive shaft on joint part in a vice with
⊳
protective jaws.
- Lever the cover -1- off with a screwdriver.
Notes:
♦ If the cover cannot be levered out, we rec-
ommend the re-insertion of the screwdriver
on the opposite side and then lever out the
cover.
♦ The cover will be damaged when levered off
and it is no longer required for assembling
the drive shaft.
plastic hammer until the compressed
circlip expands
40
------------ 40-51 ------------