Skoda OCTAVIA Workshop Manual page 32

40
------------ 40-4 ------------
Front Suspension
Removing and installing track con-
trol arm
Special tools, testers and aids required
♦ Removing tool MP 6-425
♦ Supporting device MP 9-200
♦ Torque wrench 75 ... 400 Nm,
e.g. V.A.G 1576
♦ Torquing angle wrench, e.g. V.A.G 1756
Removing
- Take off the wheel trim; pull off cap on light-
alloy wheels (hook included in tool kit).
- Jack up vehicle until no weight is pressing
on the front suspension.
- Slacken twelve-point nut.
- Raise vehicle and take off wheel.
- Unscrew twelve-point nut.
- Remove noise insulation panel.
⇒ Engine, Mechanical Components; Repair
Group 10; Removing and installing engine
Only for models with automatic gearbox:
K - Insert supporting device MP 9-200 and take
up weight of engine/gearbox in this position.
All models:
Note:
Mark installation position of the bolts -1- other-
wise the axle geometry must be checked.
K - Unscrew bolts -1-.
OCTAVIA
Edition 10.98
S00.5103.54.20