Skoda OCTAVIA Workshop Manual page 77

OCTAVIA
Edition 06.05
S00.5103.68.20
Front Wheel Suspension
- Tighten the warm-type clamp by turning the
spindle with a torque wrench (do not tilt the
pliers during this process)
A - Spindle of tensioning pliers
B - Cutting edges of tensioning pliers
C - Torque wrench
Fig. 10
⊳
- Position the tensioning pliers, e.g. V.A.G
1682, as shown in the Fig. Make sure the
cutting edges of the pliers are positioned in
the corners (arrows -B-) of the warm-type
clamp.
- Tighten the warm-type clamp by turning the
spindle with a torque wrench (do not tilt the
pliers during this process).
A - Spindle of tensioning pliers
B - Cutting edges of tensioning pliers
C - Torque wrench
Fig. 11
⊳
The sealing surface of the joint boot must be
positioned up to the stop on the shoulder of
the shaft.
Fig. 12
⊳
1 to 1 1 /
2
shaft
Note:
The above-mentioned condition regarding the
fitting position is valid also for the joint boot for
inner CV joint ∅ 94 mm.
Tighten warm-type clamp at inner
joint
Fitting position of the joint boot for
the outer joint ∅ 90 mm on the left
shaft
Fitting position of the joint boot for
the outer joint ∅ 84 mm on the left
and right shaft
groove must be visible on the drive
40
------------ 40-43 ------------